StudentPilot.com is a PilotMall.com publicationShop pilot supplies ›

IFR Flight Plan: How to File It, with a Filled Example

An IFR flight plan is required before you fly under instrument flight rules in controlled airspace: 14 CFR 91.173 says you must file one and receive an ATC clearance. You file it on the FAA international (ICAO) format, FAA Form 7233-4, through Flight Service or an approved filing app, ideally at least 30 minutes before departure. It must include the basic flight plan items in 91.153(a) plus an alternate airport unless the 1-2-3 rule in 91.169 says you do not need one.

Everything below is checked against the current eCFR Part 91 and the Aeronautical Information Manual, Chapter 5 (Change 3, effective July 9, 2026). It belongs to our instrument rating guide.

IFR flight plan requirements at a glance

Requirement Rule What it means for you
File and get a clearance 14 CFR 91.173 No IFR flight in controlled airspace without a filed IFR flight plan and an ATC clearance.
Flight plan contents 91.169(a), 91.153(a) Aircraft ID, type, PIC name and address, departure point and time, route, altitude, true airspeed, destination, time en route, fuel on board, persons on board, plus an alternate when required.
Alternate (1-2-3 rule) 91.169(b) Alternate required unless the destination has an instrument approach and, from 1 hour before to 1 hour after ETA, the forecast is at least 2,000 ft ceiling and 3 SM visibility.
Alternate weather minimums 91.169(c) Forecast at the alternate at your ETA: 600-2 for a precision approach, 800-2 for a nonprecision approach, unless the chart publishes other alternate minimums.
Fuel 91.167 Enough to reach the destination, then the alternate (if required), then 45 minutes at normal cruise (30 minutes for helicopters).
Form AIM 5-1-6, Appendix 4 FAA Form 7233-4 (ICAO format) for civil domestic IFR, except civilian stereo route filers.
Timing AIM 5-1-6 File at least 30 minutes before your estimated departure time.

Which form: FAA Form 7233-4

Civil IFR flight plans use the international (ICAO) format. AIM 5-1-6 says FAA Form 7233-4 (or DD Form 1801) is mandatory for domestic IFR flights except military/DoD flights and civilians filing stereo route flight plans, and AIM Appendix 4 repeats that the international format is mandatory for any flight plan filed through Flight Service or an FAA-contracted filing service, with those same two exceptions. FAA Order JO 7110.10EE, Flight Services (Chapter 6, Section 2; Change 3 effective July 9, 2026), gives Flight Service the same rule.

So the older domestic form, FAA Form 7233-1, still exists, but only DoD users and civilian stereo route filers may use it. If you learned on 7233-1, the information is the same; it just lives in different numbered items, and the equipment codes are different.

You will rarely fill in the paper form. Filing apps and the Flight Service website build the ICAO strings for you from an aircraft profile. Set up that profile carefully once, with your instructor or the aircraft owner, because ATC issues clearances based on the capabilities you file.

How to file an IFR flight plan

  1. Get a briefing and plan the route. Check weather, NOTAMs and the route (see “Choosing a route” below). Under 14 CFR 91.103, for any IFR flight you must become familiar with all available information, including weather reports and forecasts, fuel requirements, alternatives if the flight cannot be completed, and known traffic delays.
  2. Decide on an alternate using the 1-2-3 rule, then confirm the alternate itself meets 91.169(c).
  3. Compute fuel to destination, to the alternate, plus 45 minutes (91.167).
  4. File. Options: Flight Service by phone at 1-800-WX-BRIEF (1-800-992-7433), the Flight Service website at 1800wxbrief.com, or an electronic flight bag app that files through Flight Service or an FAA-contracted flight plan filing service (AIM Appendix 4). AIM 5-2-3 adds that the Chart Supplement lists the frequency or phone number for clearance delivery at many non-towered airports.
  5. File early. AIM 5-1-6 asks for at least 30 minutes before your estimated time of departure. Changes should be made more than 46 minutes before the proposed departure time with your original filing provider; inside 46 minutes, coordinate through ATC or Flight Service (AIM 5-1-12).

Most centers delete a proposed flight plan that has not been activated at least 2 hours after its proposed departure time, so tell ATC or Flight Service if you will be 2 hours or more late (AIM 5-1-13).

Worked example: a filled IFR flight plan

Here is an illustrative flight plan for a Cessna 172 with a WAAS GPS, a VOR receiver, an ILS receiver, a Mode C transponder and UAT ADS-B Out, flying from Lakeland, Florida, to Gainesville, Florida. The route and alternate are examples only; check current charts, NOTAMs and weather for any real flight.

Form 7233-4 item Entry Meaning
7 Aircraft identification N1234X Registration, no dashes
8 Flight rules / type I / G IFR; general aviation (AIM Appendix 4 says type of flight need not be filed for a domestic U.S. flight)
9 Type / wake category C172 / L ICAO type designator; light wake category
10a Equipment S, G, B S = VHF radio, VOR and ILS; G = GNSS; B = LPV approach capable. Item 18 adds NAV/SBAS for WAAS.
10b Surveillance C, U1 C = transponder with Mode C; U1 = UAT ADS-B Out
13 Departure / time KLAL 1430 Departure airport and proposed time in UTC
15 Speed / level / route N0110 A060 DCT 110 knots true; 6,000 ft; direct (GPS)
16 Destination / EET / alternate KGNV 0105 KOCF Gainesville; 1 hour 5 minutes en route; Ocala as alternate
18 Other information NAV/SBAS (plus the SUR/ entry your filing service adds for ADS-B) Capability details
19 Supplementary Endurance 0430, persons on board 2, PIC name and contact Kept by the filing service for search and rescue; not sent to ATC

Speed is entered as N followed by four digits (knots), altitude as A followed by three digits in hundreds of feet, and times in UTC (AIM Appendix 4). For domestic flights the FAA does not require voice or approach capability codes, but they are permitted, and you do not need to indicate Mode S capability (AIM Appendix 4).

The alternate: the 1-2-3 rule and alternate minimums

Under 91.169(b), you can omit the alternate only if both are true for the first airport of intended landing:

  • It has a published (Part 97) instrument approach, and
  • For at least 1 hour before and 1 hour after your ETA, the forecast is a ceiling of at least 2,000 feet and visibility of at least 3 statute miles.

If you do need an alternate, 91.169(c) says it qualifies only if the forecast at your ETA there is at or above the alternate minimums printed for its approach, or if none are printed, the standard minimums: ceiling 600 feet and 2 miles for a precision approach, 800 feet and 2 miles for a nonprecision approach. An airport with no instrument approach can be an alternate only if the forecast allows descent from the MEA, approach and landing under basic VFR. Check the approach charts for nonstandard alternate minimums or a note that alternate use is not authorized. Fuel planning in 91.167 uses the same 1-2-3 test, so whenever the rule requires an alternate, your required fuel must include the leg to it.

IFR flight plan checklist
14 CFR 91.167, 91.169, 91.173; AIM 5-1-6 and 5-2
  • Need an alternate? 1 hr before to 1 hr after ETA: below 2,000 ft or 3 SM, or no approach = yes.
  • Alternate legal? Charted alternate minimums, or 600-2 precision / 800-2 nonprecision at ETA.
  • Fuel: destination + alternate (if required) + 45 min at normal cruise.
  • Form: FAA 7233-4, equipment codes match the airplane today.
  • File: at least 30 min before ETD; no duplicate plans.
  • Clearance: C clearance limit, R route, A altitude, F frequency, T transponder code.
  • Void time: if not off, tell ATC as soon as possible (no later than 30 min after).
  • Close: towered field closes it on landing; non-towered, you cancel.
Verify against current eCFR and AIM before every checkride. · StudentPilot.com

Choosing a route

AIM 5-1-6 asks you to describe the route clearly: airways with their transition points, named fixes, or for GPS-equipped aircraft, direct routings defined by fixes your navigation database can recall. Where they exist, file a preferred IFR route; AIM 5-1-6 says it is to your advantage and points to the preferred routes published in the Chart Supplement and the FAA’s preferred routes database. ATC may also assign a SID or STAR. Check the low-altitude en route chart for MEAs on your route. You can get IFR en route low altitude charts at PilotMall.

Getting your IFR clearance

At a towered airport, call clearance delivery (or ground, if there is no clearance delivery frequency) shortly before taxi; where pre-taxi clearance programs exist, call no more than 10 minutes before proposed taxi time (AIM 5-2-1). State your call sign, location, “IFR to” your destination. At a non-towered airport, use the frequency or phone number in the Chart Supplement (AIM 5-2-3).

AIM 4-4-3 lists what a clearance normally contains (clearance limit, departure procedure, route, altitude and any holding instructions), and departure frequency and a transponder code are added with it. Pilots remember the order as CRAFT:

  • Clearance limit, normally your destination airport (“cleared to Gainesville airport”)
  • Route, often “as filed” or with a departure procedure
  • Altitude, such as “climb and maintain 3,000, expect 6,000 ten minutes after departure”
  • Frequency for departure control
  • Transponder code

Read it back and ask about anything unclear. “Cleared as filed” does not include your filed altitude; the altitude is always stated or you are told when to expect it (AIM 5-2-6).

Void times and hold for release

From a non-towered airport you may get a clearance that is void if you are not airborne by a certain time. AIM 5-2-7 says that if you do not depart before the void time, you must tell ATC your intentions as soon as possible, no later than the time ATC gives you, which cannot exceed 30 minutes; after that, search and rescue begins. Departing after the void time is not an IFR departure and may violate 91.173. “Hold for release” means you may not depart on that clearance until ATC releases you. AC 90-66C adds that an IFR release is not a takeoff clearance: announce your departure on the CTAF and check for traffic first.

Canceling an IFR flight plan

Section 91.169(d) requires you to notify Flight Service or ATC when you cancel or complete an activated flight plan. AIM 5-1-15 explains how:

  • You may cancel anytime you are in VFR conditions outside Class A airspace by saying “cancel my IFR flight plan.” Radar services stop unless you request VFR advisories.
  • Landing at an airport with an operating tower closes the plan automatically.
  • At an airport without an operating tower, you must cancel, by radio before landing if weather permits and you may lose contact low, or by phone after landing.

AIM 5-1-15 notes that canceling while still airborne, when you can, quickly releases the airspace for other aircraft. Lost radio procedures are covered in our lost communications guide.

Gear for IFR planning

Flight planning still happens on paper for many students, and the checkride examiner will expect you to explain every box.

What you'll need

Tools that make IFR flight planning and filing easier to learn.

ASA Flight Planner Pad
ASA Flight Planner Pad
ASA Instrument Flying Handbook (FAA-H-8083-15B)
ASA Instrument Flying Handbook (FAA-H-8083-15B)
ASA IFR Holding Pattern Visualizer
ASA IFR Holding Pattern Visualizer
ASA E6B Paper Flight Computer
ASA E6B Paper Flight Computer

Next steps: learn holding pattern entries, review the instrument rating requirements, and see how filing shows up in Task IR.I.C of the Instrument Rating ACS and in the instrument oral exam. Our flight planning guide covers the VFR side.

Frequently asked questions

Do I need an IFR flight plan to fly IFR?

Yes, in controlled airspace. 14 CFR 91.173 says no person may operate an aircraft in controlled airspace under IFR unless they have filed an IFR flight plan and received an appropriate ATC clearance.

What form is used to file an IFR flight plan?

Civil pilots use the international (ICAO) format, FAA Form 7233-4. The AIM says it is mandatory for domestic IFR flights except military flights and civilian stereo route flight plans, which may still use the older domestic Form 7233-1.

How far in advance should you file an IFR flight plan?

AIM 5-1-6 recommends filing at least 30 minutes before your estimated time of departure to avoid delays in getting your clearance. Changes should be made more than 46 minutes before the proposed departure time with your original filing provider.

When do you need an alternate on an IFR flight plan?

Under 14 CFR 91.169, you need an alternate unless the destination has an instrument approach and the forecast from 1 hour before to 1 hour after your ETA is at least a 2,000 foot ceiling and 3 statute miles visibility. This is the 1-2-3 rule.

What are the standard alternate minimums?

If the approach chart does not publish alternate minimums, 91.169(c) requires a forecast at your ETA of at least 600 feet and 2 statute miles for a precision approach, or 800 feet and 2 statute miles for a nonprecision approach. Without any instrument approach, the forecast must allow descent from the MEA and landing under basic VFR.

How do you cancel an IFR flight plan?

In VFR conditions outside Class A airspace, tell ATC “cancel my IFR flight plan.” Landing at an airport with an operating tower closes it automatically; at an airport without one, you must cancel by radio or by phone.

Back to the Instrument Rating guide