The instrument ACS is the FAA’s Instrument Rating Airplane Airman Certification Standards, FAA-S-ACS-8C, effective May 31, 2024 and still the current edition as of November 2026. It lists every Area of Operation and Task you can be tested on in the instrument knowledge test, the oral, and the checkride, with the knowledge, risk management, and skill standards for each. Download the free PDF from faa.gov below, then check off all 22 Tasks with our interactive tracker.
Get the official documents: download the Instrument Rating Airplane ACS, FAA-S-ACS-8C (PDF) and its companion, the ACS Companion Guide for Pilots, FAA-G-ACS-2 (PDF). Both are free on the FAA’s ACS library page, which is the place to confirm the current edition before your checkride. Prefer paper you can tab? See the instrument rating study materials at PilotMall.
Instrument ACS task checklist
The tracker below lists every Area of Operation and Task in FAA-S-ACS-8C so you can mark each one as you master its knowledge (K), risk management (R), and skill (S) elements. Pick your class rating to see the Tasks your checkride covers; the two engine-out Tasks apply only to multiengine applicants.
Instrument rating ACS task tracker
Check off the knowledge, risk management and skill elements of each Task as you master them. Your progress stays in this browser.
I. Preflight Preparation
- IR.I.A Pilot Qualifications
- IR.I.B Weather Information
- IR.I.C Cross-Country Flight Planning
II. Preflight Procedures
- IR.II.A Aircraft Systems Related to Instrument Flight Rules (IFR) Operations
- IR.II.B Aircraft Flight Instruments and Navigation Equipment
- IR.II.C Instrument Flight Deck Check
III. Air Traffic Control (ATC) Clearances and Procedures
- IR.III.A Compliance with Air Traffic Control Clearances
- IR.III.B Holding Procedures
IV. Flight by Reference to Instruments
- IR.IV.A Instrument Flight
- IR.IV.B Recovery from Unusual Flight Attitudes
V. Navigation Systems
- IR.V.A Intercepting and Tracking Navigational Systems and DME Arcs
- IR.V.B Departure, En Route, and Arrival Operations
VI. Instrument Approach Procedures
- IR.VI.A Non-precision Approach
- IR.VI.B Precision Approach
- IR.VI.C Missed Approach
- IR.VI.D Circling Approach
- IR.VI.E Landing from an Instrument Approach
VII. Emergency Operations
- IR.VII.A Loss of Communications
- IR.VII.B One Engine Inoperative (Simulated) during Straight-and-Level Flight and Turns
- IR.VII.C Instrument Approach and Landing with an Inoperative Engine (Simulated)
- IR.VII.D Approach with Loss of Primary Flight Instrument Indicators
VIII. Postflight Procedures
- IR.VIII.A Checking Instruments and Equipment
Task list from the FAA Instrument Rating Airplane ACS, FAA-S-ACS-8C.
What the Instrument ACS is
The Airman Certification Standards define what you must know, what risks you must manage, and what you must be able to do to earn an instrument rating in an airplane. FAA-S-ACS-8C is the current edition. The FAA’s ACS library lists it with an April 2024 publication date and an effective date of May 31, 2024 (the PDF cover itself reads November 2023, the edition date the regulations cite).
The ACS is not just guidance. It is incorporated by reference into the regulations at 14 CFR 61.14 and listed in Appendix A to Part 61, which names FAA-S-ACS-8C as the standard for both the instrument rating and the instrument proficiency check in airplanes. The same document governs your checkride and every IPC you take afterward.
The eight Areas of Operation mirror the flight proficiency list in 14 CFR 61.65(c). For the hours and endorsements you need before you can test, see our instrument rating requirements guide.
All Areas of Operation and Tasks
FAA-S-ACS-8C has 8 Areas of Operation and 22 Tasks. A single-engine applicant (ASEL or ASES) is responsible for 20 of them; Tasks VII.B and VII.C apply only to multiengine tests.
| Area of Operation | Tasks |
|---|---|
| I. Preflight Preparation | A. Pilot Qualifications; B. Weather Information; C. Cross-Country Flight Planning |
| II. Preflight Procedures | A. Aircraft Systems Related to IFR Operations; B. Aircraft Flight Instruments and Navigation Equipment; C. Instrument Flight Deck Check |
| III. ATC Clearances and Procedures | A. Compliance with ATC Clearances; B. Holding Procedures |
| IV. Flight by Reference to Instruments | A. Instrument Flight; B. Recovery from Unusual Flight Attitudes |
| V. Navigation Systems | A. Intercepting and Tracking Navigational Systems and DME Arcs; B. Departure, En Route, and Arrival Operations |
| VI. Instrument Approach Procedures | A. Non-precision Approach; B. Precision Approach; C. Missed Approach; D. Circling Approach; E. Landing from an Instrument Approach |
| VII. Emergency Operations | A. Loss of Communications; B. One Engine Inoperative (Simulated) during Straight-and-Level Flight and Turns (AMEL, AMES); C. Instrument Approach and Landing with an Inoperative Engine (Simulated) (AMEL, AMES); D. Approach with Loss of Primary Flight Instrument Indicators |
| VIII. Postflight Procedures | A. Checking Instruments and Equipment |
Every one of the 22 Tasks has all three element types (K, R, and S). That differs from the private pilot ACS, where two Tasks have no skill elements.
How instrument ACS codes work
Each element has a unique code built from four parts. Take IR.I.B.K3:
- IR: the ACS (Instrument Rating Airplane)
- I: Area of Operation I, Preflight Preparation
- B: Task B, Weather Information
- K3: Knowledge element 3 (meteorology for IFR flight)
Some elements have lettered sub-elements, such as IR.I.B.K3i (icing and freezing level information). When an element has sub-elements, the examiner may pick the element and test at least one sub-element. A few Tasks carry notes that require more: for Weather Information, an examiner who selects K2 or K3 must assess at least three sub-elements.
The examiner does not have to test every element. For each applicable Task, the ACS requires at least one knowledge element, at least one risk management element, all skill elements unless a note says otherwise, and any element you were shown to be deficient in on the knowledge test.
The skill tolerances you fly to
These are the most common standards in the skill elements, quoted from FAA-S-ACS-8C. Your examiner grades against these numbers.
| Situation | Standard |
|---|---|
| Instrument flight (IR.IV.A) | Altitude ±100 feet, heading ±10°, airspeed ±10 knots, bank ±5° in turns |
| Clearances, holding, en route | Airspeed ±10 knots, heading ±10°, altitude ±100 feet, no more than 3/4-scale CDI deflection |
| Intercepting and tracking (IR.V.A) | Airspeed ±10 knots, altitude ±100 feet, headings ±5°; a DME arc ±1 NM |
| Non-precision final (IR.VI.A) | 3/4-scale CDI, airspeed ±10 knots, MDA +100/−0 feet to the VDP or MAP |
| Precision final (IR.VI.B) | No more than 3/4-scale deflection of vertical or lateral guidance, airspeed ±10 knots |
| Circling (IR.VI.D) | Altitude +100/−0 feet until descending; land in the first third of the runway without exceeding 30° of bank |
Appendix 3 of the ACS adds the approach requirements: at least two different non-precision approaches, which must include a course reversal, a procedure flown from an initial approach fix without autopilot or radar vectors, and a procedure flown with backup or partial panel instrumentation, plus one precision approach to the decision altitude. If your airplane has an IFR-approved RNAV or RNP system, you must show approach proficiency using it. Holding is covered in detail in our holding patterns guide.
How the knowledge test maps to the ACS
The instrument written (test code IRA) draws its questions from the knowledge and risk management elements in this ACS. The ACS table lists 60 questions, a minimum age of 15, and a 70 percent passing score. One correction matters: the ACS prints a 2.5-hour time limit, but the FAA’s ACS Knowledge Test Table correction gives the correct allotted time as 2.0 hours.
Your Airman Knowledge Test Report lists an ACS code for each question you missed. Those codes point to specific elements, so you and your instructor can review exactly those topics, and the examiner is required to retest them during the practical test. The test must be passed within the 24 calendar months before the month you complete the checkride, per 14 CFR 61.39. Applicants who already hold an instrument rating in another category do not take another instrument knowledge test. See our instrument written exam guide for study strategy.
What changed from the old PTS
Older books refer to the Instrument Rating Practical Test Standards, FAA-S-8081-4E. The ACS replaced it for airplanes in June 2016. The PTS focused on flying skills; the ACS keeps those standards and adds explicit knowledge and risk management elements to every Task, each with a code tied to the knowledge test.
FAA-S-ACS-8C, the current edition, made several changes from 8B:
- Added sub-elements listing specific weather products (METAR, TAF, GFA, winds aloft, convective outlook, AIRMET, SIGMET) and route planning sources (charts, Chart Supplements, NOTAMs, Terminal Procedures Publications).
- Expanded the risk management elements for unusual attitude recovery and added a knowledge element on regaining visual conditions after inadvertent IMC.
- Added skill elements for electronic flight bag use, autopilot procedures, holding leg length, and SRM or CRM in several Tasks.
- Archived two elements (IR.IV.B.R2 and IR.VII.C.R2) and moved non-regulatory material to FAA-G-ACS-2.
If your study material still says PTS, or cites FAA-S-ACS-8B, check it against the current edition.
Special cases in the ACS
The instrument proficiency check
An IPC under 14 CFR 61.57(d) uses this same ACS. At minimum the pilot must perform holding (III.B), unusual attitude recovery (IV.B), intercepting and tracking (V.A), all five approach Tasks (VI), the loss of primary instruments approach (VII.D), the multiengine engine-out Tasks if applicable (VII.B and VII.C), and postflight (VIII). An approved advanced aviation training device can cover most of an IPC, but the circling approach, landing, and multiengine Tasks must be done in an aircraft or a qualified full flight simulator. Our currency and IPC guide covers when you need one.
Testing in a single-engine airplane with a multiengine rating
If you hold both single-engine and multiengine class ratings and take the instrument checkride in a single-engine airplane, your certificate will carry the limitation “Multiengine Limited to VFR Only.” Testing in a multiengine airplane confers instrument privileges for single-engine too.
Combined private and instrument test
Under 61.65(a) and (g) you can test for the private certificate and instrument rating together. You must pass all Areas of both ACS documents, Tasks are not duplicated, and it counts as one test: failing any Task, even a VFR one, fails the whole application. See our private pilot ACS guide for that half.
How to study with the Instrument ACS
- Read the introduction and Appendix 1. They explain exactly how the examiner builds a plan of action and grades you.
- Use the Task list as your syllabus map. For each Task, read the K, R, and S elements to see the depth expected.
- Take the written early, then work through every missed ACS code before the oral.
- Fly to the tolerances on every lesson, not just the mock checkride.
- Practice risk management out loud: for each Task, name what could go wrong and how you would mitigate it. Our instrument oral exam questions are organized by these same Tasks.
Bring a current copy of the ACS to the checkride and know where the tolerances are. When the examiner asks about a standard, opening the ACS to the right Task shows the kind of resource use the ACS evaluates under single-pilot resource management.
When you are ready for test day, our instrument checkride guide walks through the ground and flight portions, and our ACS and checkride prep guide explains how the ACS works across every certificate.
Instrument ACS study materials
What you'll need
The printed ACS, handbook, and test prep instrument students use most, all from PilotMall.com.
Under 14 CFR 61.45(d)(2) you must furnish a view-limiting device for the checkride that blocks your outside view but not the examiner’s, so pack your foggles or hood with your documents.
Frequently asked questions
What is the current instrument ACS?
FAA-S-ACS-8C, Instrument Rating Airplane Airman Certification Standards, effective May 31, 2024. It is still the current edition on the FAA ACS library page as of November 2026.
Where can I download the instrument ACS PDF?
The FAA publishes it free at faa.gov/training_testing/testing/acs, along with the FAA-G-ACS-2 companion guide that explains how the standards are applied.
How many Tasks are in the instrument rating ACS?
There are 8 Areas of Operation and 22 Tasks. Single-engine applicants are tested on 20 of them, because the two engine-out Tasks in Area VII apply only to multiengine airplanes.
What do the codes on my knowledge test report mean?
Each code, such as IR.I.B.K3, identifies the ACS, the Area of Operation, the Task, and the specific element you missed. Review those elements with your instructor, because the examiner must retest them on the checkride.
Does the instrument ACS apply to an IPC?
Yes. 14 CFR 61.57(d) requires the IPC to use the applicable ACS, and FAA-S-ACS-8C lists the minimum Tasks for an airplane IPC, including holding, unusual attitudes, tracking, all approach Tasks, and the partial panel approach.





